How to Calibrate Your Hoverbord?

When and why you should calibrate your hoverboard

After the board has been used continuously, or one rear occasions, incorrect calibration, the hoverboard may shake, or move incorrectly. If this is only the first time this happens, it is usually due to the calibration being out of sync.

Other common issues include when the foot pads of the hoverboard are not flat (level) when a user is standing on the hoverboard. This is because the hoverboard is out of sync due to calibration issues.

When your hoverboard is experiencing any of these issues, the best cost saving solution is to calibrate the board. The following steps will help you calibrating your device:

Hoverboard Calibration Steps

  1. Make sure your hoverboard is fully charged. (this takes approximately 2 hours).
  2. Once the hoverboard is fully charged, disconnect the hoverboard from the charger and disconnect any other devices connected to the hoverboard via bluetooth.
  3. Switch the hoverboard off using with the power button. For the calibration of the hoverboard be successful, the hoverboard needs to be fully shut down. Avoid putting the board to sleep using the remote.
  4. Put the hoverboard on a flat surface and make sure that it is perfectly level. Should you continue with the calibration and the board is not level, it will calibrate to that configuration.
  5. Press and hold down the power button. Whilst doing this, the Bluetooth will be enabled. You will then hear a beep sound, continue to hold down the power  button down for around 5 seconds.
  6. Hold down the power button for a couple of seconds to switch off the hoverboard.
  7. Wait for a further 30 seconds. After the 30 seconds have passed, you may now press the power button to switch the board on.

 

Leave a Reply

Your email address will not be published. Required fields are marked *